Filter
Top Products
VIZIO
®
VW46L FHDTV20A User Manual
Version 10/20/2008 11
www.VIZIO.com
1.4 VIZIO Remote Control
GUIDE – This button displays program information. Press this button once when in TV mode and the
information of the program being viewed is shown.
POWER – Press this button to turn the TV on from the Standby mode. Press it again to return to the
Standby mode.
HDMI – Press this button to select the HDMI input. By pressing it repeatedly you will go through the three
(HDMI 1, HDMI 2 and HDMI 3) inputs in sequence.
MUTE – This button turns the sound on and off.
TV – Press this button to select TV.
COMPONENT – Press this button to select the Component (YPbPr)
input. By pressing this button repeatedly you will be switching from
Component 1 to Component 2 and vice versa.
LAST – This button recalls the previously viewed channel. If the On-
Screen Display (OSD) menu is being used, this button will allow you to
get back to previous menu screen or out to your program when you
press it repeatedly.
AV – Press this button to select AV (either Composite or S-Video) input.
MENU – Use this button for the On-Screen Display (OSD) menu. When
it is used within a menu selection, pressing this key will help you to
make the selection of the feature to be adjusted after it has been
highlighted.
-These labeled buttons are used to navigate the OSD
menu. When navigating the OSD menu, the arrows control the direction
up and down or left and right. They will also be used as value settings
when the slide bar is shown on the screen and option settings to turn a
feature off or on.
hen
NUMBER BUTTON PAD – Use these buttons to select a channel or
enter a password.
INPUT – This button allows the user to
cycle through the inputs. Repeatedly
pressing of this button will step you
through the input sources in the
following sequence: TV, AV (S-VIDEO),
Component1, Component2, RGB,
HDMI1, HDMI2, and HDMI3. Once you
have stepped through the entire
sequence, you will return to the
beginning.
- (DASH) – When selecting a digital
channel directly use this button for the
separation of main and sub-channels.
For example, channel 28-2 would be
selected by the button sequence 2 8
ENTER 2.