Filter
Top Products
10
Setting up the RX240 Receiver
Step 1: Install the Receiver Batteries
Insert the rechargeable battery into the bottom of the RX240 Receiver
(see page 11). Place the receiver into the charger cradle built into the top
of the TX240 Transmitter and let charge overnight. The spare battery can
be plugged into the charging port located on either side of the transmitter.
By keeping the spare battery charged, you can easily swap batteries
when the one in use runs out and always have a fresh battery ready. A
fully charged battery will operate the receiver for approximately 7 hours,
depending on the volume setting. The battery should be changed when
you notice the sound getting weak and noisy. The batteries may be left
charging when not in use.
Step 2: Using the WIR RX240 Receiver
The RX240 will automatically congure itself for stereo or mono (2.3 or 2.8
MHz) operation depending on the setup chosen for the TX240 Transmitter.
To use the system, rst check to make sure your TV or audio source is
turned ON. Make sure the receiver battery is fully charged. The RX240
Receiver has an automatic on/off function. When you put the receiver on,
it turns on. When you take the receiver off, it turns off. Rotate the volume
control to adjust the volume to a comfortable level.
IMPORTANT: A dual detector infrared “eye” is located in the front
of the receiver. Do not cover it up or you will lose reception. Make
sure the “TV TALKER” lettering is facing away from you when you
put the receiver on.
Return the receiver to the charger when it is not in use.
Additional Receiver Adjustments
Balance Control: Use a small screwdriver to adjust the loudness balance
between the left and right earphones. See page 11.