WARNING
INSTALLATION OF THIS ANTENNA NEAR POWER LINES IS
DANGEROUS. FOR YOUR SAFETY, FOLLOW THE INSTALLATION
INSTRUCTIONS.
PR-6000 ONLY
STEP 1. Remove antenna from carton
and unfold elements, making certain the
elements lock tightly into place and are
perpendicular to the boom.
STEP 2. Attach matching transformer to
coaxial downlead. Loosen wing nuts on
downlead connection. Attach matching
transformer leads between washers on
stud rivets. Tighten wing nuts securely.
See Figure 1.
STEP 3. Mount antenna on mast, point-
ing front (small end) towards stations
and tighten mast clamp securely. See
Figure 2.
STEP 4. Use electrical tape to secure
coax to mast. Ground antenna for per
Safety Instructions. See Figure 4 on
back side of instruction sheet.
Fig. 1
Fig. 2
ATTACH DOWNLEAD HERE
MASTING
2” OD MAX.
MAST CLAMP
U-BOLT
MAST CLAMP
INSERT
HEX NUT
PR-6010 ONLY
STEP 1. Unfold antenna making sure all
4 elements snap tightly in place.
STEP 2. Place connecting mast section
into clamp riveted to antenna boom and
align holes. Insert bolt through hole and
tighten hex nut securely.
STEP 3. Attach assembled antenna to
mast, and tighten U-bolt securely. See
Figure 1.
ATTACHING DOWNLEAD
STEP 1. Attach matching transformer to
coaxial downlead. Loosen wing nuts on
downlead connection. Attach matching
transformer leads between washers on
stud rivets. Tighten wing nuts securely.
See Figure 2.
STEP 2. Use electrical tape to secure
coax to mast. Ground antenna for per
Safety Instructions. See Figure 4 on
back side of instruction.
NOTE: When installing FM antenna
on same mast as TV antenna, allow
at least 4 feet between antennas. See
Figure 3.
Fig. 1
Fig. 2
Fig. 3
MAST SECTION
ANTENNA BOOM
