Filter
Top Products
3
Trouble Shooting
No power light after pressing power button.
Antenna won't raise. The Up, Motion, Down lights
blink after pressing Up/Down Button.
a. Check that 12VDC power source is on. –fix power, if OK, go to step b.
b. Remove Control Panel, remove power cable and check for 12VDC across
red and black wires. – if OK, go to step c.
c. Replace Control Panel. – Still doesn't work, go to D.
d. Contact your Dealer or Winegard Company.
PROBLEM
SOLUTION
a. Check for obstructions that prevent antenna head from raising.
Examples tree branches, snow or ice, etc.
Antenna won't rotate when fully raised.
a. Check for obstructions that prevent antenna head from rotating.
Examples tree branches, snow or ice, etc.
b. Check that antenna is in full raised position. Antenna will not rotate
if not fully raised.
Antenna won't rotate and lower when pressing
Up/Down Button. The Up, Motion, Down lights
blink after pressing a Rotate Button.
a. Check for obstructions that prevent antenna head from rotating
and lowering. Examples tree branches, snow or ice, etc.
Picture quality poor.
a. Is antenna power supply turned on and working properly?
b. Are you in a location that receives good TV Signals from TV
station?
c. Is there a fellow RV that can verify they can receive a signal?
d. Did you rotate antenna to try and improve signal
e. Disconnect coax at antenna head and check for 12VDC between
coax center conductor and connector. If you have proper voltage,
antenna head may be bad. If no voltage, check that power supply
is working properly. If it is working properly check for shorts or
opens in coax between power supply and antenna.
f. Check connections between power supply and TV/Video center etc.
g. Contact your Dealer or Winegard Company.
Need to move RV and Antenna system won't
lower to roof.
a.
If for some reason you cannot automatically
lower antenna and need to drive your RV, you
can manually lower antenna. If antenna is in up
position physically grip turret and rotate very
slowly in the CW direction until you hit the
internal mechanical stop at which time the
wings of the Antenna head should be inline with
length of RV. While holding turret with one
hand, use other hand to slowly push antenna
head down and toward rear of RV. This will
place antenna system in driving position until
you can receive service.