Filter
Top Products
50
75
65
60
55
45
40
FIGURE 4
Coil Coax
Around
Clips
Reflector
FIGURE 1
Point Towards Satellite
Use Front of Slide
Bracket for Proper
Degree of Elevation
Required. Unit shown
at 50
o
.
Clamp Knobs
0 Degrees Elevation
(Next Mark Indicates 5
0
)
LNBF
FIGURE 2
Reflector Support
Post
FIGURE 3
Use Front of Slide
Bracket for Proper
Degree of Elevation
Required. Unit shown
at 60
o
.
RETURNING ANTENNA TO TRAVEL POSITION
STEP 1. Turn receiver and TV OFF.
STEP 2. Disconnect coax from receiver.
STEP 3. Loosen clamp knobs and put antenna in travel
position. See Figure 3.
STEP 4. Coil coax under base. See Figure 4.
NOTE: The carton the system came in is designed to
be reused. It is suggested that you store your
system in it when not in use.
NOTE: When ready to use antenna again, you must
uncoil the coax before raising antenna. The antenna
will not raise if the coax is coiled up under the base.
TOP VIEW