Winegard RD-4646 Satellite TV System User Manual


 
3
ROOF ELEVATING SHAFT W/RW-1000 DIRECTIONAL
THICKNESS LENGTH HANDLE LENGTH
4 3/4" 6 1/4" RP-4200 req. 5 3/8"
4 1/2" 6" RP-4200 req. 5"
4 1/4" 5 3/4" 6 1/4" 4 3/4"
4" 5 1/2" 6" 4 1/2"
3 3/4" 5 1/4" 5 3/4" 4 1/4"
3 1/2" 5" 5 1/2" 4"
3 1/4" 4 3/4" 5 1/4" 3 9/16"
3" 4 1/2" 5" 3 3/8"
2 3/4" 4 1/4" 4 3/4" 3 1/16"
2 1/2" 4" 4 1/2" 2 3/4"
2 1/4" 3 3/4" 4 1/4" 2 3/8"
2" 3 1/2" 4" 2 1/16"
1 3/4" 3 1/4" 3 3/4" 1 3/4"
1 1/2" 3" 3 1/2" 1 3/8"
1 1/4" 2 3/4" 3" 1"
Directional
Handle
FIGURE 2
NOTE: Make sure that coax cable
fits between the reflector and the
fixed feed arm.
(4) 5/16-18
Hex Nut
(4) 5/16"
Flat Washer
(4) 5/16-18 x 5/8"
Flat Head Bolt
Rev. 6/05/01
STEP 4. Attach reflector to backup
assembly as shown in Figure 2.
The mount is designed to fit roofs 1" to 4 3/4" thick. If roof is less than 4 3/4" thick, cut elevating shft and directional
handle to size. (See table below.) If roof is more than 4 3/4" thick, contact Winegard Company.
CAUTION: IF YOU ARE USING THE RW-1000 ROOF WEDGE, ADD 1/2" TO ELEVATING SHAFT LENGTH
GIVEN BELOW, BUT NOT TO THE DIRECTIONAL HANDLE.