Winegard SS-1000 TV Antenna User Manual


 
2
7
Adjusting your Square Shooter for best reception when
trying to receive signal in an area with reflected signal.
For the best reception, we suggest you have someone watching the
TV while you adjust the antenna.
NOTE: See Figure 5 for bolt locations covered in the following steps.
Skew bracket bolts.
Loosen to adjust tilt, Step 3.
Pipe clamp bolts.
Loosen to adjust azimuth,
Step 1.
Elevation angle bracket bolt.
Loosen to adjust elevation angle,
Step 2.
Figure 5
T
T
T
T
STEP 1. To adjust azimuth, loosen the 2 bolts on
the pipe clamp and rotate antenna on pipe. Rota-
tion can be up to 90°.
Step 2. To adjust the elevation angle, loosen
the bolt and nut at the bottom of the curved slot.
Adjust the angle of the antenna.
STEP 3. To adjust the skew, loosen the 4 bolts
holding the elevation bracket. Now twist (turn) the
antenna for the best picture.
CAUTION!
RISK OF
ELECTRIC SHOCK.
DO NOT OPEN!
RISK OF ELECTRIC SHOCK
DO NOT OPEN
10A. If the appliance is equipped with a polarized
alternating-current line plug (a plug having one
blade wider than the other) this plug will fit into the
power outlet only one way. This is a safety feature.
If you are unable to insert the plug fully into the
outlet, try reversing the plug. If the plug should still
fail to fit, contact an electrician to replace your
obsolete outlet. Do not defeat the safety purpose of
the polarized plug.
10B. If the appliance is equipped with a 3-wire
grounding-type plug, a plug having a third (ground-
ing) pin, this plug will only fit into a grounding-type
power outlet. This is a safety feature. If you are
unable to insert the plug into the outlet, contact an
electrician to replace your obsolete outlet. Do not
defeat the purpose of the grounding-type plug.
11. Power-supply cord should be routed so that it is
not likely to be walked on or pinched by items
placed upon or against it, paying particular
attention to cord at plug, convenience receptacle
and the point where cord exits from the appliance.
12. If an outside antenna or cable system is con-
nected to this video product, be sure system is
grounded so as to provide some protection against
voltage surges and built-up static charges. Proper
method is shown at the top of the next page.
13. An outside antenna system should not be
located in the vicinity of overhead power lines or
other electric light or power circuits, or where it can
fall into such power lines or circuits. When installing
an outside antenna system, extreme care should
be taken to keep from touching such power lines or
circuits as contact with them might be fatal.
14. For added protection for this video product
during a lightning storm, or when it is left unat-
tended and unused for long periods of time, unplug
it from the wall outlet and disconnect the antenna
or cable system.
WARNING: TO REDUCE RISK OF FIRE OR
ELECTRICAL SHOCK,
DO NOT EXPOSE TO RAIN OR MOISTURE.
(Not applicable to mount and antenna)
Dangerous voltage
inside enclosure
Refer to operating, mainte-
nance and safeguard literature
accompanying unit.
IMPORTANT SAFEGUARDS
1. All the safety and operating instructions should
be read before the appliance is operated.
2. The safety and operating instructions should
be retained for future reference.
3. All warnings on the appliance and in the
operating instructions should be adhered to.
4. All operating and use instructions should be
followed.
5. Unplug this video or audio product from the wall
outlet before cleaning. Do not use liquid cleaners
or aerosol cleaners. Use a damp cloth for clean-
ing.
6. Do not use attachments not recommended by
the video product manufacturer as they may cause
hazards.
7. Do not use this video product near water - for
example, near a bath tub, wash bowl, kitchen
sink, or laundry tub, in a wet basement, or near a
swimming pool, and the like.
8. If slots, holes and openings are located in the
housing, they are provided for ventilation and to
ensure reliable operation of the video product
and to protect it from overheating. These open-
ings should never be covered. The openings
should never be blocked by placing the video
product on a bed, sofa, rug, or other similar
surface. This video product should never be placed
near or over a radiator or heat register. This video
product should not be placed in a built-in installa-
tion such as a bookcase or rack unless proper
ventilation is provided or the manufacturer's in-
structions have been adhered to.
9. This video product should be operated only
from the type of power source indicated in electri-
cal rating printed on the appliance or power sup-
ply.
CAUTION: TO REDUCE RISK OF ELECTRICAL SHOCK,
DO NOT REMOVE COVER, NO USER-SERVICEABLE PARTS INSIDE.
REFER SERVICING TO QUALIFIED PERSONNEL
T
T
T
T
T
T
Rotation bracket.