Filter
Top Products
4 5
Installation
Attaching the Antenna with reflector to the Base
1. Route the 6’ Mini Coax Cable through the Base and screw it securely to the
Antenna.
2. Slide the Antenna with Reflector onto the Base.
3. Using a screw driver slightly tighten the two screws, (see Fig. 7), to secure
the Antenna to the Base.
Installation (cont.)
Attaching the Reflector to the Antenna
1. Starting from the right side, slide the Clip that is attached to the Reflector
diagonally into the notch at the back of the Antenna. (See Fig. 4, 5)
2. Once the Clip is pushed in, slide it to the side so that it forms a 90 degree
angle to the Antenna’s edge. (See Fig. 6)
3. Repeat steps 1 and 2 for all four Clips.
Fig. 6
Fig. 4
Fig. 7
Fig. 5
$17(11$
79
32
:
(5
$17(11$
79
32:(5
Fig. 8
2’ Coax
Cable
6’ Coax
Cable
Connecting the
1. Connect the Mini Coax Cable
that is attached to the Antenna
to the Power Injector labeled
“Antenna”.
2. Connect the 2’ Coax Cable
from the Power Injector
labeled “TV” to your HDTV
or Set-up box.
3. Connect the 6’ Standard Coax
Cable from the Power Injector
labeled “Power” to the AC
Adapter.
4. Plug in the AC Adapter to a
standard AC outlet.
Attaching Rubber Feet to the Base
Remove the protective adhesive
strip from the four rubber feet and
apply them to the bottom of the
antenna base.
SharpSh oter
TM
Fig. 9
Feet