Filter
Top Products
Installation 11
MAN0094 (11/15/2002)
HYDRAULIC INSTALLATION
Keep hands and body away from pressurized
lines. Use paper or cardboard, not hands or other
body parts to check for leaks. Wear safety gog-
gles. Hydraulic fluid under pressure can easily
penetrate skin and will cause serious injury or
death.
Make sure that all operating and service per-
sonnel know that if hydraulic fluid penetrates
skin, it must be surgically removed as soon as
possible by a doctor familiar with this form of
injury or gangrene, serious injury, or death will
result. CONTACT A PHYSICIAN IMMEDIATELY IF
FLUID ENTERS SKIN OR EYES. DO NOT DELAY.
Make sure all hydraulic hoses, fittings, and
valves are in good condition and not leaking
before starting power unit or using equipment.
Check and route hoses carefully to prevent dam-
age. Hoses must not be twisted, bent sharply,
kinked, frayed, pinched, or come into contact with
any moving parts. Operate moveable components
through full operational range to check clear-
ances. Replace any damaged hoses immediately.
Install Pump Kit 9261
NOTE: For complete information on pump kit installa-
tion, consult the Woods BH6500/7500 backhoe oper-
ators manual 37541.
NOTE: Discard pump mounting bracket provided in
pump kit 9261
1. Attach pump mounting bracket 37917 (supplied
with sub-frame mounting kit #1004624) to pump
assembly using cap screw and locknut as shown
in Figure 14.
2. Torque hardware to 85 lbs.-ft.
3. Attach pump mounting bracket with bent leg
toward tractor as shown in Figure 15.
1. Pump assembly with adapter
2. Pump mounting bracket
3. 1/2 NC Hex locknut
4. Tractor drawbar bracket
5. 1/2 NC x 1-1/2" Hex head cap screw
6. Tractor PTO shaft
Figure 14 Bump Bracket Installation Figure 15 Pump & Bracket Installed
4
3
2
1
6
CD4696
5