Filter
Top Products
7
Pre-Wiring
CAT-5 Wiring between MRC88m and MRKP1E
The MRC88m and all associated components are wired using CAT-5
terminated to the T568A or T568B Wiring Standard (Figure 2.1). When pre-
wiring the system, run lengths of CAT-5 from the pre-determined MRC88m
location to each Keypad or Touch Panel location. The CAT-5 cable routes all
Power, Control, Communication, and IR information needed for full system
operation.
Important: While there are two wiring standards, it is very important to be
consistent to one configuration throughout the entire system. Otherwise, the
system will not operate.
Note: Speaker wiring will need to be separately routed from the MRC88m to
each zone.
Figure 2.1: T568A and T568B Wiring Standard
16
USER SETUP PARAMETERS
BALANCE
Adjust audio output level on the right or left channel. The settings can be adjusted from
“-31” to “0” (middle) to “+31”
TREBLE
Adjust the higher frequency range of audio output. The settings can be adjusted from “-
14” to “0” (middle) to “+14”
BASS
Adjust the lower frequency range of audio output. The settings can be adjusted from “-
14” to “0” (middle) to “+14”
BL COLOR
Gives option to change the Text color and keypad backlighting to Blue or Green.
GO HOME (Return to Main Setup Menu)
After configuring the above parameters, user can choose to SAVE, NO SAVE, or
RESTORE the settings above.
INST SETUP PARAMETERS
QUICK CONFIG
Launches Xantech Quick Config. Function. Press X” to start process. Refer to the
Dragon Quick Config manual for details on setting up Quick Config.
KP ADDR (Keypad address)
Assigns a different keypad address for each keypad when using multiple keypads in one
zone.
OLED BRIGHT (Display Brightness)
Adjust the display brightness to DIM, MEDIUM, or BRIGHT.
LED BRIGHT (Button and Volume LED Brightness)
Adjust the button backlight brightness to DIM, MEDIUM, or BRIGHT.
BL TMR VAL (Backlight Timer)
Adjust the time when the backlight will turn off for energy savings when there is no
activity. Setting are “ON” (always on), “30 SEC (turns off after 30 sec), and “1 MIN”
(turns off after 1 minute).
GO HOME (Return to Main Setup Menu)
After configuring the above parameters, user can choose to “SAVE”, “NO SAVE”, or
“RESTORE” the settings above.