Filter
Top Products
Configuration
12 975-0210-01-01
Viewing the Setup Menu
You can use the RV Series Remote Controls to configure the
RV Series Inverter/Charger and the remote itself.
Configuration is performed using the Setup menu. You can
view the Setup menu and configure settings by using the
Setup/Menu Item buttons and the Settings button.
To view the Setup menu and enter Setup mode, press and
hold the two Setup/Menu Item buttons for approximately five
seconds, or until the screen clears, then release the buttons.
You can scroll through menu items by pressing the up or
down arrow buttons.
To exit Setup mode, press and hold the Setup/Menu Item
buttons for approximately five seconds until the screen
changes back to the System Status Display.
Changing Settings
You can change settings using the Settings button while in
Setup mode. This button scrolls through menu items one at a
time. If you pass the desired item or setting, continue pressing
the Settings button until the item or setting reappears.
You can also use the Settings button to enable or disable the
equalize charge mode.
Figure 3-1
Setup/Menu Item Buttons
Figure 3-2
Settings button
Meter Mode
Menu Item
Setup
Settings
RC-GS_manual.book Page 12 Thursday, May 26, 2005 4:58 PM