Xerox XM7-22w Flat Panel Television User Manual


 
Installation
14
Xerox© LCD Monitor User’s Manual
Method 2: Digital (DVI) Connection
1 Turn off the computer and unplug the power cord.
2 Connect the DVI signal cable to the DVI port
on the back of the computer.
3 Connect the audio cable to the out port on the back of the
computer.
4 Connect the power cord to the LCD monitor and wall outlet.
5 Press the button, located on the bottom side of the main
unit to turn the monitor on, then turn the computer on. If the
monitor displays an image, the monitor is successfully
installed. If no image is displayed, check all connections.
6 When the DVI and VGA input ports are connected at the
same time, press down the AUTO button after 3 seconds to
switch between the VGA mode and DVI mode.
Connect to power source
4
2
Connect to the DVI port
Connect to the out port
3
Note: HDCP has been implemented across the DVI interface. The HDCP specification provides a cost-effective
and transparent method for receiving the highest quality digital entertainment content from HDMI compliant
video sources. (Specified for HDCP models)
2 D-SUB+1 DVI