Filter
Top Products
30 En
SETUP MENU
Surround L/R
Set the distance from your listening position to the
surround speakers. We recommend to place the surround
left speaker and right speaker at the same distance from
the listening position.
Control range: 1ft to 40ft (0.3m to 12.0m)
Control step: 1ft (0.3m)
For the [Surround L/R] setting, you cannot specify the distance
beyond the [Front L/R] setting or below the [Front L/R] setting
minus 15ft (4.5m).
Initialize
You can reset [Distance] settings to the initial factory
settings.
1 Select [Initialize] under [Distance] in
[SPEAKER] menu.
2 Press .
➜ The confirmation screen appears.
3 Select [Yes] to reset the setting, and then press
ENTER.
➜ [Distance] settings are reset to the initial factory
settings.
Setting speaker levels
You can set the volume levels for individual speakers.
• Select [Level] in [SPEAKER] menu.
Front L, Center, Front R, Surround L, Surround R,
Subwoofer
Set the volume levels for front L/R speakers, center
speaker, surround L/R speakers or subwoofer.
Control range: 0dB to –12dB
Control step: 1dB
Test Tone
A test tone can be output to help you judge the volume
level of each speaker.
1 Select [Test Tone] under [Level] in [SPEAKER]
menu.
2 Press / to select [Off], [Manual] or [Auto].
Off
Select this to output no test tone.
Manual
Select this to output the test tone manually.
Auto
Select this to output the test tone from each speaker
automatically.
3 For [Auto], press ENTER to output the test tone.
For [Manual], press
/ to select each
speaker, and then press
ENTER to output the test
tone.
When the CD disc is being loaded in the disc tray, the test tone is
output from only front L/R speakers.
Initialize
You can reset [Level] settings to the initial factory settings.
1 Select [Initialize] under [Level] in [SPEAKER]
menu.
2 Press .
➜ The confirmation screen appears.
3 Select [Yes] to reset the setting, and then press
ENTER.
➜ [Level] settings are reset to the initial factory
settings.
Setting the SA-CD configuration
You can select speaker sizes and on/off statuses for
SA-CD discs.
• Select [SA-CD Config] in [SPEAKER] menu.
Config 1, Config 2, Config 3
Select speaker sizes and on/off statuses from the following
three settings.
Setting the cut-off frequency
(SA-CD only)
You can select a cut-off (cross-over) frequency for all low-
frequency signals. All frequencies below the selected
frequency are sent to the subwoofer.
• Select [CUT-OFF Frequency] in [SPEAKER]
menu.
60, 80, 100, 120 (Hz)
Select the cut-off frequency.
Note
Note
Speaker
Size or on/off
Config 1 Config 2 Config 3
Front L/R Large Small Large
Center Large Small Small
Surround L/R Large Small Small
Subwoofer On On Off
01EN_03_Setup_DVD-S1700_U.fm Page 30 Tuesday, December 26, 2006 4:27 PM