Filter
Top Products
19
English
Settings on the device in which the mLAN8E is installed
•
mLAN8E input settings
An mLAN input plug of the mLAN8E can have only one connection.
(1) Turn knob [A] to select the mLAN8E mLAN plug that will input the signal. The module name
and plug name for the destination device will be displayed as “-----”.
If a connection has already been established, the current connection desti-
nation will be displayed. Also, the display will indicate “[ENTER] To Cut”
above knob 2. In this case, press [ENTER] to break that connection.
(2) Turn knob [C] to select an mLAN device on the mLAN bus (system). The upper line will show
the vendor name, and the lower line will light the module name.
(3) Turn knob [1] to select an mLAN input plug on the destination mLAN device, and press
[ENTER] to execute the connection.
To change an existing connection, you must first break the connection and
then specify a new connection.
If the names (vendor name, module name, mLAN plug name) of the con-
nected device exceed eight characters, only the first eight characters will be
displayed.
mLAN connections tone generators are saved in the mLAN8E. They cannot
be saved on a memory card.
mLAN W
ord Clock
Select the Word Clock.
■
Mode
Select whether the CS6x/CS6R/S80 will function as the Word Clock Master (Group 1 Master)
of the connected mLAN Audio network, or whether the slave/master setting will be selected
automatically (auto). When you select the Mode and press [ENTER], a confirmation screen will
appear. To execute the setting press [YES]. To cancel press [NO]. When the setting has been
finalized, the display will indicate “(int)” or “(ext=********)” at the right of Mode. “(int)” indi-
cates that the CS6x/CS6R/S80 in which the mLAN8E is installed is acting as the word clock
master. “(ext=********)” indicates that it is acting as the slave of an external module named
“********”.
❑
Setting:
auto (44.1 kHz), Group1Master (44.1 kHz)
This setting is stored in the mLAN8E. It cannot be saved on a memory card.
NOTE
NOTE
NOTE
NOTE
NOTE
mLAN WordClock) Mode [ENTER]
Sys Group1Master(44.1kHz) to Set
NOTE