Filter
Top Products
29
English
Setup Menu
Setting the HDMI audio
If you are not using the HDMI audio
output, you should set this to [Off].
If the monitor/receiver connected to this
player using HDMI does not support
HDMI audio signal input, set this to [Off].
1 In ‘AUDIO SETUP PAGE’, press 34 to
highlight [HDMI AUDIO], then press 2.
Notes:
– Super Audio CD signals cannot be output
using HDMI.
– This player can output following audio
signals using HDMI: 32/44.1/48 kHz, 2ch
linear PCM signals and bitstream signals
(Dolby Digital, DTS and MPEG).
– When audio signals are being output by
HDMI-compatible components, digital
output signals are muted.
ON
Select this to turn on the HDMI audio
output.
OFF
Select this to turn off the HDMI audio
output.
Speaker Setup
This menu contains setup options for
audio output so that you can set your
speakers to reproduce high quality
surround sound. For details, see page 13.
CD upsampling
This feature allows you to convert your
music CD to a higher sampling rate using
sophisticated digital signal processing for
better sound quality. If you have activated
the upsampling function, the player will
automatically switch to stereo mode.
1 In ‘AUDIO SETUP PAGE’, press 34 to
highlight [CD UPSAMPLING], then press
2.
OFF
Select this to disable CD-upsampling.
88.2 kHz (X2)
Select this to convert the sampling rate of
CDs to twice that of the original.
176.4 kHz (X4)
Select this to convert the sampling rate of
CDs to four times that of the original.
2 Press 34 to select a setting, then press
ENTER/OK to confirm your selection.
Note:
– This setting is only valid for signals output
from the analog jacks.
Night Mode
In this mode, high volume output is
softened and low volume output brought
upward to an audible level. It is useful for
watching your favorite action movie
without disturbing others at night.
1 In ‘AUDIO SETUP PAGE’, press 34 to
highlight [NIGHT MODE], then press 2.
ON
Select this to level out the volume. This
feature is only available for movies with
Dolby Digital mode.
OFF
Select this when you want to enjoy the full
dynamic range of surround sound.
2 Press 34 to select a setting, then press
ENTER/OK to confirm your selection.
TIPS: To return to the previous menu, press 1.
To clear the menu, press SETUP.