Zenith H25F39DT Flat Panel Television User Manual


 
PAGE 9
Cable Service (CATV) with VCR Hook Up
Connect a VCR and Cable service to the Concierge TV
Leave the VCR and the television tuned to channel
three and use the cable box to change channels.
No A/V cables are included with the TV.
TV Back
TV Back Panel
(Expanded View)
VIDEO
IN
ANTENNA
CABLE
SPEAKER
OUT
AUDIO
IN
Cable TV
Wall Jack
Cable Box
In
Out
3 4
Output
Switch
A/V Cables
Not included
with TV
RF Coaxial Wire
(75ohm)
In
Out
Audio
Video
3 4
VCR Back
VCR Back AV Panel
Output
Switch
TV Back
TV Back Panel
(Expanded View)
VIDEO
IN
ANTENNA
CABLE
Super
Port
SPEAKER
OUT
AUDIO
IN
Cable TV
Wall Jack
A/V Cables
Not included
with TV
RF Coaxial Wire
(75ohm)
In
Out
Audio
Video
3 4
VCR Back
VCR Back AV Panel
Output
Switch
Locate the Antenna/Cable jack on the back
of the VCR.
Connect the cable service wire that runs
from the wall, according to one of the dia-
grams to the right. Make other connections
as needed.
Remove the back of the remote and put in
two AA batteries.
Plug in the TV. The Concierge TV is designed
to operate on standard current, 120-volt 60
Hertz AC. Do not attempt to operate it on
DC power.
Go to page 11 to Auto Program the TV.
Back of
Remote
120 V AC
60 Hz
1
2
3
4
5