A SERVICE OF

logo

9
6 Connecting the PoE Power Injector
To connect the wireless bridge to a power source:
1 Connect the Ethernet cable from the wireless bridge to the RJ-45 port labeled “Output” on
the power injector.
2 Connect a straight-through unshielded twisted-pair (UTP) cable from a local LAN switch to
the RJ-45 port labeled “Input” on the power injector. Use Category 5e or better UTP cable
for 10/100BASE-TX connections.
CAUTION: Do not install the power injector outdoors. The unit is for indoor installation
only.
NOTE: The wireless bridge’s Ethernet port does not support Power over Ethernet (PoE)
based on the IEEE 802.3af standard. Do not try to power the unit by connecting it directly
to a network switch that provides IEEE 802.3af PoE. Always connect the unit to the
included power injector.
NOTE: The RJ-45 port on the power injector is an MDI port. If connecting directly to a
computer for testing the link, use a crossover cable.
Ground Wire
Ethernet Cable