398 CHAPTER 11: MANAGED ACCESS POINT COMMANDS
set load-balancing
mode
Disables or reenables RF load balancing globbaly on the WXMAP.
Syntax —
set load-balancing mode {enable | disable}
enable — Enables RF load balancing globally on the WX.
disable — Disables RF load balancing globally on the WX.
Defaults — RF load balancing is enabled by default.
Access — Enabled.
History — Introduced in MSS Version 6.0.
Usage — By default, RF load balancing is enabled on all MAP radios.
Use this
command to disable or re-enable RF load balancing globally for
all MAP radios managed by the WX.
If RF load balancing has been enabled or disabled for a specific MAP
radio, then the setting for the individual radio takes precedence over the
global setting.
Examples — The following command globally disables RF load
balancing for all
MAP radios managed by the WX switch:
WX# set load-balancing mode disable
WX#
See Also
display load-balancing group on page 348
set load-balancing strictness on page 399
set band-preference on page 397
set ap radio load balancing on page 389
