Chapter 2 7
This chapter contains step-by-step procedures on how to disassemble and reassemble the Studio MMP3400
for maintenance and troubleshooting.
Disassembly/Reassembly Requirements
To disassemble or reassemble the computer, you need the following tools:
• Wrist grounding strap and conductive mat for preventing electrostatic discharge
• Philips screwdriver (may require different size)
• Tweezers
NOTE: The screws for the different components vary in size. During the disassembly process, group the
screws with the corresponding components to avoid mismatch when putting back the components.
Pre-disassembly Instructions
Before proceeding with the disassembly procedure, make sure that you do the following:
1. Turn off the power to the system and all peripherals.
2. Unplug the AC adapter and all power and signal cables from the system.
3. Place the system on a flat, stable surface.
Machine Disassembly and Replacement
Chapter 2
