© Adam Equipment Company November 2011
9
Parameters
Description
1.
BLT
Enable / disable the backlight
2.
CHK
Enable / disable the check-weighing facility
3.
FIL
Enable / disable the ADC filter rate
4.
SDT
Sets the RS-232 output function.
Options are 1, 2, 3 and 4.
5.
PAT
Sets the following parity options-
8 n 1 -
8 data bits, no parity
7 E 1 -
7 data bits, even parity
7 0 1 -
7 data bits, odd parity
6.
BPS
Changes the baud rate for RS-232 transmission
speed. Options are 1200, 2400, 4800 and 9600.
4.1 BLT = BACKLIGHT CONTROL
• When “BLT” is displayed press the [Unit] key to change
setting
“BLT= 0FF“ Backlight is disabled.
“BLT= O
n
” Backlight is enabled.
• Press the [Mode] key to store the setting and move on.
4.2 CHK = CHECK WEIGHING CONTROL
• When “CHK” is displayed press the [Unit] key to change
setting
“CHK= 0FF“ Check weighing is disabled.
“CHK= O
n
” Check weighing is enabled.
• Press the [Mode] key to store the setting and move on.
4.3 FIL = FILTERING CONTROL
• When “FIL” is displayed press the [Unit] key to change
setting.
“FIL= 0FF“ Filtering function is disabled.
“FIL= O
n
” Filtering function is enabled.
• Press the [Mode] key to store the setting and move on.
