A SERVICE OF

logo

3
Installing the SlimSCSI 1450
3
(Optional) Connect up to two additional SCSI devices by daisy-
chaining them to the first device, as shown below:
4
Be sure that each SCSI device has a unique SCSI ID ranging
from 0 to 6. If any two devices have the same ID, change the
SCSI ID of one device. This is usually done by changing a
switch on the back of the device. (For more information, see
SCSI IDs on page 8.)
The diagram below shows a typical SCSI device with a select-
able SCSI ID switch:
5
Terminate the last (or only) SCSI device connected to the
SlimSCSI 1450. Read the device documentation if you are not
sure how to terminate the device, or refer to Terminating the
SCSI Bus on page 9.
SCSI Devices
Terminator