Ground Lift (16, 19)
Connecting the Receiver to
Power
Important!
Transmitter SILENT Mode
Receiver LOCK Mode
Optional
external MUTE switch
4 Setting Up
9
DMS
700
The receiver will automatically detect an external 48 kHz clock and then use the external clock.
You can check theWordclock status in the Channel Information window.
This switch allows you to remove hum caused by ground loops.
• To open the chassis ground connection,set the GROUND LIFT switch to the LIFT position.
You can check the GND LIFT status in the Channel Information window.
• Check that theAC mains voltage stated on the rear panel is identical to theAC supply
voltage available where your system will be used. Using the power supply with a dif-
ferentAC voltage may cause damage to the unit.
• Plug the power cord into theAC IN socket(25) on the receiver’s rearpanel and the otherend of
the power cord into a convenient power outlet.
We recommend setting the carrier fre-
quency in SILENT mode only (RF OFF).
• To engage SILENT mode, push and
hold theMUTE switch (2)while turning
on (6) the transmitter. This is the only
wayto makesureyouwon'tgo "onair"
on a frequency that is not allocated or
coordinated and risk "jamming" or interfering with some other RF device or wireless system.
The receiver is electronically locked so that you won’t make any unintended adjustments.
The "LOCK" label (D) is shown on the display.
• Toenter SETUPmode, press andhold the SELECTcontrol (5) untilthe "LOCK" labeldisappears.
After approximately 4 minutes with no action, the receiver will automatically switch into LOCK
mode.
• To disable the automatic LOCK function,call up the AUTOLOCK sub-menu and select "OFF".
The optional RMS 4000 Remote Mute Switch allows muting of the transmitter if it is mounted in a
position where it is difficult or impossible to use the "on-board" MUTE switch.
▲
!
DMS 700_2_Quad Manual_F031103 21.03.2011 15:12 Uhr Seite 9
