CRK; Reviewed:
SPOC 7/1/2011
Solution & Interoperability Test Lab Application Notes
©2011 Avaya Inc. All Rights Reserved.
5.7. Configure SIP Endpoint
This section describes the steps for administering OPS stations in Communication Manager and
associating the OPS station extensions with the telephone numbers of SpectraLink 8400 Series.
Enter add station s, where s is an extension valid in the provisioned dial plan. The following
fields were configured for the compliance test.
Type – Set to 9630SIP.
Name – Enter a descriptive name
Repeat this step as necessary to configure additional SIP endpoint extensions.
Add station 28002 Page 1 of 6
STATION
Extension: 28002 Lock Messages? n BCC: 0
Type: 9630SIP Security Code: TN: 1
Port: S30168 Coverage Path 1: 99 COR: 1
Name: WiFi-1 Coverage Path 2: COS: 1
Hunt-to Station:
STATION OPTIONS
Time of Day Lock Table:
Loss Group: 19
Message Lamp Ext: 28002
Display Language: english Button Modules: 0
Survivable COR: internal
Survivable Trunk Dest? y IP SoftPhone? n
On Page 6 of the STATION form, enter the trunk group number that was assigned in Section 5.6
for the SIP Trunk field.
add station 28002 Page 6 of 6
STATION
SIP FEATURE OPTIONS
Type of 3PCC Enabled: None
SIP Trunk: 201
Enter the add off-pbx-telephone station-mapping command and configure the following:
Station Extension – Set the extension of the OPS station as configured above.
Application – Set to OPS.
Phone Number – Enter the number that SpectraLink 8400 Series will use for registration
and call termination. In the example below, the Phone Number is the same as the
Station Extension, but is not required to be the same.
Trunk Selection – Set to the trunk group number configured in Section 5.6.
Config Set – Set to 1
Repeat this step as necessary to configure additional off-pbx-telephone station-mapping.
add off-pbx-telephone station-mapping 28003 Page 1 of 3
STATIONS WITH OFF-PBX TELEPHONE INTEGRATION
Station Application Dial CC Phone Number Trunk Config Dual
Extension Prefix Selection Set Mode
28002 OPS - 28002 201 1
