Chapter 2 Avaya C460 CLI Commands
Avaya C460 Reference Guide 143
show arp-aging-interval
User level: read-only, read-write, admin.
Use the show arp-aging-interval command to display the ARP table aging
interval for gateway entries.
The syntax for this command is:
show arp-aging-interval
Example:
show arp-tx-interval
User level: read-only, read-write, admin.
Use the show arp-tx-interval command to display the keep-alive frames
transmission interval.
The syntax for this command is:
show arp-tx-interval
Example:
show banner login
User level: read-only, read-write, admin.
Use the show banner login command to display the message shown before a login.
The syntax for this command is:
show banner login
C460-1> show arp-aging-interval
ARP table aging interval for gateways was set to 10
minutes.
C460-1> show arp-tx-interval
ARP tx interval for inband interface is set to 5 seconds.
ARP tx interval for outband interface is set to 5 seconds.
