The Unit is operating normally on AC power.
The Unit is operating on battery power.
The alarm will stop when main AC power
The battery energy is running low. This alarm
will continue until the Unit performs a forced
shutdown when the battery is depleted.
A fault has occurred. Disconnect all
equipment from the Unit prior to checking.
The Unit is overloaded. Remove connected
equipment until fault mode is cleared.
The battery has reached the end of its useful
life. The user must replace the battery as
soon as possible to ensure proper operation
LED Indicators and Audible Alarms
The Unit will alarm to indicate certain events.
Low Battery press and hold Overload
AC Power Battery Power Fault Replace Battery
NOTE: The audible alarm will not sound after the alarm is muted.
The Unit contains a fully functional, detachable
LED flashlight. The flashlight will automatically
illuminate when the power goes out. This safety
function provides an easy way for you to find the
flashlight while illuminating the area surrounding
the Unit. The LED flashlight may be removed from
the Unit to use as a handheld, portable flashlight.
To remove the LED flashlight from the Unit’s
recharging dock, pull the top of the LED flashlight
out and downward until it disengages. When
not in use, return the LED flashlight to the Unit’s
recharging dock. The LED flashlight will only
fit one way in the recharging dock: with the
flashlight lens pointing toward the top of the Unit
and the LED flashlight button toward the outside.
The LED flashlight will only recharge if properly
Flashlight Recharging and Battery Replacement
• The detachable LED flashlight contains 3
NiMH 700mAh AAA batteries. When replacing
batteries, replace with the same number
and type of batteries. Do not attempt to use
alkaline or other non-NiMH battery types
• Risk of energy hazard. Before replacing
batteries, remove conductive jewelry such as
chains, wristwatches, and rings.
through conductive materials could cause
• Do not short-circuit the batteries.
• Carefully install the batteries in the LED
flashlight housing, ensuring proper polarity.
Reverse polarity installation may cause
damage. The battery installation polarity is
labeled on the LED flashlight housing.
• Do not heat or incinerate the battery. The
• Only use the UPS Unit to recharge the
batteries. Charging under other conditions
can cause the battery to leak, overheat, burst,
• Properly dispose or recycle used batteries.
