USING YOUR ROUTER
22
Configure the parameters below.
User Name and Password: Enter the user name and
password provided by the ISP. The user name and
password are used to log in to the ISP server.
Retype Password: Enter the password again.
Service Name: If several PPPoE servers are
available, specify which server to use.
IP assigned by ISP: You can select either to an IP address assigned
by your ISP, or to manually set an IP address in the “IP Address” field.
MTU: The maximum transmission unit. We strongly
recommend you to use the default setting unless
your ISP gives you a specific MTU setting.
If you select the “Disconnect after xxx minutes of no
activity” check box and specify a time interval, the system
interrupts the Internet connection when there is no
Internet access behavior within the specified time.
Click “Apply Changes”.
If after a few minutes your Internet Status says
“Connected”, you’re done! You can surf the Internet.
PPTP/L2TP Connection
Some ISPs require a connection using the PPTP or L2TP protocol.
Enter the account and password provided by your ISP.
The following takes PPTP connection as an example.
Setup steps:
Click “Connection Type” in the left column
under the “Internet WAN” heading.
Select “PPTP” in the “Connection Type” page that appears.
