51118 5
Rev. A 1298
Installing the Doors
Warning:
The doors in this product are designed only for protection against the elements. Do not rely on the doors to contain
occupants within the vehicle or to protect against injury during an accident. Door handles are only designed to aid in door
closure. Door and handle
will not
support a person's weight.
Step One
To install the new fabric covers on the original door frames, first you must remove the old doors from your vehicle and take the door
handles off.
Note: Be careful in dismantling the handles, there is a spring inside each of the handles and they must be put back together just as
they came apart.
Step Two
With a razor knife, cut the stitching on the old door covers and remove them from the frames.
Step Three
Start with the front of the door cover and locate the cut outs in the fabric for the door pins. Insert the door pins through the cut outs in
the fabric and place the "First" corner into the pocket sewn into the fabric. Work around the door, slipping each corner into each corner
of the elastic band. It may be necessary to unzip the upper window before sliding the elastic over the last corner.
Third Corner
Last Corner
Adhesive Hook Strip
Second Corner
First Corner
Door Pins
Figure 4
Step Four
After the fabric door covers are on the frames, install the adhesive hook on the door frame to match up with the loop strip sewn into the
fabric cover. Use a pair of scissors to cut a hole in each door for the handle and reinstall the handle. Make sure that you replace it the
way it came off.
