14
Setting the station
There are a number of ways to set the sta-
tion.
Automatic station search
➮ Press the or button, 7.
The next station that can be received is tuned
in.
Manual station tuning
You can also tune to the station manually:
➮ Press the or button, 7.
Setting station search sensitivity
You can choose whether to search only for
stations with strong signals, or whether weak
stations should be included:
➮ Select the waveband (AM or FM) to
which the setting should apply.
➮ Press the MENU button, 8.
➮ Press the or button, 7, until “FM-
SENS” or “AM-SENS” appears in the
display.
➮ Press the button or , 7.
The current sensitivity value is shown on the
display. “SENS 6” indicates the maximum
sensitivity for the reception of distant trans-
mitters, and “SENS 1” indicates the lowest
sensitivity.
➮ Set the desired sensitivity by pressing
or , 7.
➮ Press the OK button, 5, or the MENU
button, 8, to leave the menu. The set-
tings are then saved.
Saving a station
Saving a station manually
➮ Choose the desired memory level: FM I,
FM II, FMT, M or MT.
➮ Tune in the desired station as described
under “Setting the station”.
➮ Hold down the softkey, 4, indicating
the position [(“ST1” - “ST6”) where the
station is to be stored] for longer than
two seconds.
Saving a station automatically
(Travelstore)
You can also save the six strongest stations
in the area automatically. This is done in the
FMT and MT memory levels.
Note:
Any stations previously saved on this level will
be deleted.
To use the Travelstore function:
➮ Press the TUNE button, >, when the
radio is operating.
The radio function menu is shown on the dis-
play.
➮ Press the softkey, 4, indicating “TS”.
Storing starts. “T-STORE” appears in the dis-
play. When the procedure is complete, the
station in memory location 1 on the FMT or
MT level is played.
Going to a pre-set station
➮ Select the memory level or waveband.
➮ Press the softkey, 4, indicating “ST1” -
“ST6” for the desired station.
RADIO OPERATION
