Attaching Fastening Rails
used for both NKT 72 and NKT 92 series
90*
To attach the fastening rails:
I. Mark the center as shown in drawing.
2. Align rails using notch.
3. Secure the rails tightly using screws.
Note: a. The top flange of rail must sit tightly
against the counter top.
b. If counter top is tiled, the lower
screws holes in the rails should be
used.
SPECIAL NOTE:
Use plugs or sleeves for screws or glue rails in
place, using a temperature resistant two component
adhesive which is suitable for bonding metal to
stone, when installation is in granite or marble
counter top.
Important:
• Do all counter top preparation, before
installing the cook-top. Be sure to clean area
after cutting and before installing cook-top.
Chips, and other debris from cutting of the
counter may impair the function of electrical
components.
• Seal the cut surfaces with silicone rubber,
heat resistant enamel or casting resin, to seal
the surface against moisture.
