stitution will void the agencies’ certifications and the
Norcold warranty. Refer to this manual for proper in-
structions. Install the refrigerator and vents as directed
by Norcold without modification.
The clearance from the refri
erator’s left side
facin
the front of the refri
erator
to the vehicle’s exterior wall
is important. This is the area in which the inlet and outlet
flexible pipin
will be connected to the vent terminal
housin
durin
installation.
Refer to Figures 3 and 4 for
maximum clearances from refrigerator cabinet to vehi-
cle exterior wall.
The wall thickness the vent terminal housin
will
accommodate is .030" minimum to 1.250" maximum.
Fi
ure 2 illustrates the confi
uration of the openin
for
the vent terminal housin
.
Do not make the opening in
the vehicle wall larger than required.
The clearance
should be enou
h for the terminal housin
to pass
throu
h the openin
. If the openin
is too lar
e, the
outer
asket will not cover the vent housin
openin
.
It is imperative that the wall openin
for the vent
terminal housin
not be too low. The flexible pipin
inlet and outlet pipes
must rise from the refri
erator to
the terminal housin
. There are two specific vent-air
intake assembl
kits available to accommodate most
installations.
Figures 3 and 4 illustrate two installations
with the maximum flexible piping lengths and the vent
terminal housing locations.
Fi
ure 2 - Air Intake/Exhaust Assembl
Intake Pipe
max. len
th
16"
Exhaust Pipe
max. len
th
14"
Fi
ure 3 - Kit #617941 Flexible Pipin
& Vent Location
Intake Pipe
max. len
th
21 3/4"
Exhaust Pipe
max. len
th
19 3/4"
Fi
ure 4 - Kit #617943 Flexible Pipin
& Vent Location
1. Mountin
Screw 8. O Rin
s
2. Vent Cover 9. Intake Pipin
3. Outer Disk 10. Exhaust Pipin
4. Inner Disk 11. Lockin
Washer Screw
5. Rubber Gasket 12. Lockin
Washer
6. Vent Terminal 13. Vehicle Exterior Wall
Housin
Cut-Out 14. Mountin
Screw
7. Vent Terminal 15. Mountin
Screw
Housin
3
