A SERVICE OF

logo

Open as PDF
next previous
120
1
2
3
4
5
7
8
9
Preliminary Notes and
Legal Information
Contents: Basic
Operations
Camera Basics
Auto Mode/Hybrid
Auto Mode
Other Shooting
Modes
Playback Mode
Setting Menu
Accessories
Appendix
Index
Basic Guide
P Mode
Cover
Advanced Guide
6
Wi-Fi Functions
Computer Settings for Connecting via Wi-Fi (Windows
only)
On a computer running Windows, you must congure the following settings
before you can connect the camera to the computer wirelessly.
1 Conrmthecomputeris
connected to Wi-Fi.
For instructions on checking your network
connection, refer to the computer user
manual.
2 Congurethesetting.
Click in the following order: [Start] menu
► [All Programs] ► [Canon Utilities] ►
[CameraWindow] ► [Wi-Fi connection
setup].
In the application that opens, follow the
on-screen instructions and congure the
setting.
•The following Windows settings are congured when you run the utility in step
2.
- Turn on media streaming.
This will enable the camera to nd the computer to access via Wi-Fi.
- Turn on network discovery.
This will enable the computer to nd the camera.
- Turn on ICMP (Internet Control Message Protocol).
This allows you to check the network connection status.
- Enable Universal Plug & Play (UPnP).
This will enable network devices to detect each other automatically.
•Some security software may prevent you from completing the settings as
described here. Check the settings of your security software.
Adding a Computer
Add a computer to your list of devices to connect to via Wi-Fi.
Follow these instructions when using a Wi-Fi Protected Setup (WPS)
compatible access point to establish a push-button connection.
If your access point is not WPS-compatible, establish a connection as
described in “Connecting to Access Points in the List” (=
122).
•WPS makes it easy to complete settings when connecting devices over Wi-Fi.
You can use either Push Button Conguration Method or PIN Method for
settings on a WPS supported device.
•Refer to the user guide provided with your access point to check if it supports
WPS.
•Be sure to also read the user guide included with your access point.
1 Access the Wi-Fi menu.
Press the <o> button.
2 Choose a computer.
Press the <o><p><q><r> buttons to
choose [
], and then press the <m>
button.
3 Choose [Add a Device].
Press the <o><p> buttons to choose
[Add a Device], and then press the <m>
button.
A list of detected access points will be
displayed in the [Select Network] screen.
C OPY