COPYRIGHT
©
2001 CANON INC. 2000 2000 2000 2000 CANON iR2200/iR2800/iR3300 REV.0 MAR. 2001
CHAPTER 5 SERVICE MODE
5-62 T
<INSTALL>
Use it as part of installation work.
TONER-S
Use it to stir the toner inside the developing assembly.
Caution • Check to make sure that the developing assembly is securely mounted
before pressing the OK key.
• Do not execute any operation. (The Stop key may be pressed.)
Using the Mode
1) Select <TONER-S> to highlight; then, press the OK key.
2) The machine stirs toner (about 4 min), during which time a count-down
is indicated to the right of <TONER-S> from 240 to 0.
3) The machine automatically stops after stirring toner.
STRD-POS
Use it to execute automatic adjustment of the CCD read position in stream
mode.
Caution • Execute this mode when installing the ADF or if you have removed and
then installed the ADF once again.
Using the Mode
1) Select <STRD-POS> to highlight; then, press the OK key.
• The machine executes automatic adjustment.
2) The machine stops operation automatically after adjustment.
3) The settings under COPIER>ADJUST>ADJ-XY>STRD-POS is up-
dated. Record the new settings to the service label.
CARD
Use it when installing the card reader.
Using the Mode
Enter the number of the card to use. 1 to 2701 (default: 1; as many as 300
cards may be used starting with the entered number)
Use it to initialize card control information:
• initializing the card names (group ID; starting with the entered number).
• initializing ID numbers for cards.
COPIER>FUNCTION>INSTALL
