48
Recording Images
6. Touch “c” (Movie Stop) to stop recording.
• Each movie can be up to 29 minutes long. Movie recording stops automatically
after 29 minutes of recording. Movie recording also will stop automatically if
memory becomes full before you stop movie recording.
Minimizing the Effects of Camera Movement during Movie Recording
You can configure the camera to minimize the effects of camera movement during
movie recording. Note, however, that this does not prevent image blur due to subject
movement.
IMPORTANT!
• Spending a long time using movie recording will cause the camera to become
slightly warm to the touch. This is normal and does not indicate malfunction.
• The camera also records audio. Note the following points
when shooting a movie.
– Take care that the microphone is not blocked by your
fingers, etc.
– Good audio recording results are not possible when the
camera is too far away from what you are trying to
record.
• Shooting a very bright subject can cause a vertical band or
a pink cast on the monitor screen image. This does not
indicate malfunction.
• Shooting a movie using the camera’s built-in memory will cause movie frames to
be dropped. Always use a high speed memory card (not built-in memory) for movie
recording.
• Use of certain types of memory cards slows down data transfer and increases the
time it takes to record movie data, which can result in movie frames being dropped.
The movie icon turns yellow to indicate that frames are being dropped. In order to
avoid problems such as these, use of an Ultra High Speed Type SD memory card
is recommended. Note, however that CASIO makes no guarantees about the
operation of any Ultra High Speed Type SD memory card used with this camera.
NOTE
• Single SR Zoom (page 44) is disabled during movie recording.
• The effects of camera movement in an image become more pronounced when you
shoot close up or with a large zoom factor. Because of this, use of a tripod is
recommended under these conditions.
Microphone
B
