Page 7
SKU 93167 For technical questions, please call 1-800-444-3353
Boom Extension (47)
Pin
Clevis Pin No. 1
Seat (76)
Hydraulic Fluid
Reservoir
Hydraulic Fluid
Fill Plug (15)
TOW CONFIGURATION
Engine (72)
Frame Assy. (69)
Mount Hitch
Coupler (92)
Here
Control
Panel
(14)
Boom
Pivot (40)
Clevis Pin
No. 1 (33)
Main
Boom
(44)
Pin
(38)
Lug Nuts. NOTE: Make sure
to tighten (torque) the Lug Nuts
to at least 90 Ft.-Lbs.
4. Place the Seat (76) onto the
tube at the top of the Hydrau-
lic Fluid Reservoir. Attach
the Control Support (8) to the
Frame Assembly (69) using
four Hex Bolts (7). See illustra-
tion at bottom of page.
NOTE: The Hydraulics of this
unit are tested before ship-
ment. There is hydraulic fluid
ASSEMBLY
1. With the help of one or more assistants, use jacks (not included) to evenly raise the
Frame Assembly (69) & support with jack stands (not supplied). Then mount both Axles
(59) near the boom end of the frame, as shown at bottom. Secure with Lock Pins (68).
2. Place a Tire (61) over the four studs on each Hub. Secure the Tires to the Hubs, using
four Lug Nuts (60) per Tire. Make sure that the lug nuts are snug and centered in the
holes. Inflate the tires to 65 PSI.
3. Lower the Trencher and remove the jack stands. Block the tires while you tighten the
present in many components. Assemble this unit in an
area that will not be damaged by leaking hydraulic fluid
and it is recommended that you wrap rags securely over
the Hydraulic connectors on all the Cylinders (1) during
assembly. Always wear splash-resistant ANSI approved
safety goggles and other protective gear to prevent injury
from leaking fluid.
5. Attach the Main Boom (44) to the Boom Pivot (40) using Pin
(38) through the bottom hole and Clevis Pin No. 1 (33) through
the upper hole. Secure both pins with Hair Pins (32); Pin (38)
requires one Hair pin on each end. See photo below. Other
people will need to assist in the process.
REV 05j
