3.3 Programming a Sequence
Once you have programmed memories you can store them in sequences and replay these
either manually, to a beat, triggered by sound or by setting the speed.
To store a sequence go to the following menu:
Select the ProgSeq soft key. This will take you to the following menu:
It is possible to store up to 12 Sequences each of 250 steps. To select a different sequence
number use the Up or Down soft keys to select the number you want. If the number next to
Steps has a value other than 000 then it has already had memories stored in it.
To program the sequence press the soft key associated with Select. You now have two options,
Auto Seq or Steps.. If you use Auto Seq it will use all the recorded memories to make up a
sequence. If you select Steps you can make up your own sequence. Selecting Steps.. will take
you to the following screen:
This will take you to the following screen:
Use the Page + or Page – keys to take you to the page that the memory you want is on. Select
the memory by pushing the flash button the memory is stored on. Flash buttons that have
memories stored on them will have the Yellow LED lit. Each time you press a flash button the
number of steps will increment by 1. You will see the change in the top right hand corner of the
LCD display.
Page01 Step--- Run 2
Flash On ProgMem
Sound Off ProgSeq
Dir Fwd More..
Program Sequence 01
Back (000 Steps)
Up
Down Select
Step 001 Seq05
Back
Insert Step
Page01 Step 001
Back
Page+
Page-
