Make certain that the remote is installed in a location which
does not interfere with the safe and proper operation of the
is only compatible with the
Installation of Clarion Marine audio components requires expe-
rience with a variety of mechanical and electrical procedures.
Even though this Manual provides general installation and op-
eration instructions for your new Clarion Marine audio remote
control panel, it does not show the exact methods which may
be required for your particular installation.
If you do not have the required knowledge and experience to
successfully complete the installation, we strongly recommend
consulting an authorized Clarion Marine audio dealer about
professional installation options.
....................................................................
..................................................
3. Using the Remote Control Panel
..................................
4. Installation and Wiring
..................................................
5. Limited Warranty Information......................................11
Connecting the illumination lead.
The illumination circuit of the CMRCI-BSS/SB operates with
a +12V input. Wire with a .250 female insulated spade
terminal (not supplied), and connect the illumination
terminal on the rear of the panel to a 0.5A in-line fuse (not
supplied). Connect the other side of the fuse to an
illumination circuit boat.
3. Connecting the cables.
Connect the DIN cable from the
to the remote(s). Route it carefully to avoid moving parts.
Connecting one remote to the CMD4 or M455
with optional M101RXC DIN cable.
Connecting two remotes to the CMD4 or M455 using an
optional M101RYC and two M101RXC DIN cables.
NOTE: A maximum of two remotes can be connected
