AMI
Appendix A
(59)Hit<ESC> message cleared.<Wait..> message displayed. About to start DMA
and interrupt controller test. Master 8259 mask register OK, about to start slave.
(59)Check existence of adapter.
Chips & Tech (59)Exiting protected mode.
Phoenix
AMI
(59)Initialize POST display service.
Error Code - 5A
(5A)About to check timer and keyboard interrupt level.
(5A)Blank display, check VDU registers.
Chips & Tech (5A)Board memory size.
Phoenix (5A)Keyboard ready
SETUP".(Beep)=2-2-3-3
AMI
test.
Display
prompt
"press
F2
enter
(5B)Timer interrupt OK.
(5B)Start screen memory test.
Chips & Tech (5B)Shadow RAM relocated.
Phoenix (5B)Display CPU cache.
ACER
AMI
(5C)About to test keyboard and I/O.`
(5C)About to test keyboard interrupt. (5C)End
of test of adapter, clear memory.
Chips & Tech (5C)EMS configure.
Phoenix (5C)Test RAM between 512 and 640K.(Beep)=2
keyboard type.
AMI
(5D)ERROR! Timer/keyboard interrupt not in proper level.
(5D)Error detected on an adapter.
Chips & Tech (5D)Wait state configuration is set-up.
AMI
(5E)8259 interrupt controller error.
(5E)test the next adapter.
Chips & Tech (5E)1st 64K RAM re-test.
Phoenix
AMI
(5E)Enter third protected mode test.
Error Code - 5F
(5F)8259 interrupt controller test OK.
(5F)All adapters successfully
Chips & Tech (5F)Shadow RAM.
ACER (60)Set up BIOS interrupt.
AMI
AST
Award
(60)DMA page register test passed. About to go for DMA #1,verify from display
memory.
(60)RAM size.
(60)Setup virus protection(Boot sector protection).
(60)Start of memory test.
Chips & Tech (60)CMOS RAM.
Phoenix
AMI
AST
Award
(60)Test expanded memory.(Beep)=2-3-1-1.(60)Base memory test.
Error Code - 61
(61)Display memory verification over. About to go for DMA #1 base register test.
(61)RAM test.
(61)Try to turn on level 2 cache. Set the boot up speed according to setup setting.
Last chance for chipset initialization. Last chance for power management initialization. Show
the system configuration table.
(61)Enter protected mode.
Chips & Tech (61)Video.
AMI
AST
Award
Compaq
Phoenix
AMI
AST
Award
(62)DMA#1 base register test passed. About to go for DMA #2 base register test.
(62)Shadow RAM.
(62)Setup daylight saving according to setup values. Program the NUM lock, type
rate & type speed according to setup setting. Setup NUM_LOCK; Setup NUM_LOCK status
according to setup.
(62)Start memory sizing.
(62)Test extended memory address lines.(Beep)=2-3-1-3. Base memory address
test.
Error Code - 63
(63)DMA #2 base register test passed. About to go for BIOS ROM data area check. (63)Cache
memory.
(63)If there is any changes in the hardware configuration, update the ESCD information(PnP
BIOS only. Clear memory that have been used. Boot system via
INT 19h.
(63)Get CMOS size.
16
