5
1. Remove tie from power cord and unravel the
power cord.
2. Connect the front base to the rear base by
placing attached pegs into the appropriate
holes.
3. Slide the power supply cord through the
assembled base from the top. (Fig. 1)
4. Position the connected base pieces where the
front base piece is facing in the direction of
the front grill.
5. Move base so the screw holes align properly.
Using the 4 base screws provided (taped to
the Tower Heater), secure the base to the
bottom of the Tower Heater. (Fig. 2)
6. Once the base is secured, unscrew one side of
the cord holder on the bottom of the base.
Place the power supply cord in the slot and
replace the screw. The power supply cord
should now fit in the groove on the back of the
rear base. (Fig. 3)
CAUTION
Do not use your Tower Heater if it has not been
fully assembled. Make sure that the screws that
hold the base parts and the main unit together
are tightened securely.
Fig.1
Fig.2
Fig.3
NOTE:
During the first few minutes of initial use, you may notice a slight odor; this is
normal and will quickly disappear.
CAUTION: ALWAYS USE CAUTION WHEN HANDLING THE TOWER HEATER. DO NOT
DROP THE TOWER HEATER. DO NOT COVER THE VENTILATION GRILL.
Operating Instructions
1. The Tower Heater must be placed upon a firm, level surface.
2. Plug the power supply cord into an electrical outlet. Be sure plug fits tightly in
outlet. A loose fit will cause overheating and damage the plug. Plug and cord set
may feel warm during normal usage. Once plugged in, the power indicator light
will illuminate.
3. When turned on, the indicator light will illuminate red. The red indicator light will
remain lit until the control knob is turned off and the heater is unplugged from
the electrical outlet.
