0
Getting Started Connections Settings Playback Remote ControlMulti-zone Information Troubleshooting SpecificationsPlayback
Tuning in Radio Stations – FM/AM Broadcasts
If the desired station cannot be tuned in with auto tuning, tune it in
manually.
When tuning in stations manually, press and hold [TU d] or [TU f] to
change frequencies continuously.
The time (default : 30 sec) for which the GUI menu is displayed can
be set “GUI” - “Tuner” (vpage 54). Press uio p to return to
the original screen.
•
•
•
Listening to FM/AM Broadcasts
1
Press [SOURCE SELECT] to display the GUI Source
Select menu, then select “ ” (vpage 31).
2
Set the main remote control unit to the “TUNER”
mode (vpage 108 “Operating the Main Remote
Control Unit”).
3
Press [BAND] to select “FM” or “AM”.
4
Tune in the desired broadcast station.
q To tune in automatically (Auto Tuning)
Press [MODE] to select “AUTO”, then use [TU d] or [TU f] to
select the station you want to hear.
w To tune in manually (Manual Tuning)
Press [MODE] to select “MANUAL”, then use [TU d] or [TU f].
5
Adjust the items below.
Adjusting the master volume (vpage 85)
Selecting the surround mode (vpage 87)
Adjusting the Sound and Picture Quality
(vpage 90)
n
n
n
Presetting Radio Stations (Preset Memory)
Your favorite broadcast stations can be preset so that you can tune
them in easily. Up to 56 stations can be preset.
1
Tune in the broadcast station you want to preset.
2
Press [MEMO].
3
Press [A ~ G] to select the block in which the channel
is to be preset, then press [CHANNEL] or [1 ~ 8] to
select the preset number.
The memory block can also be selected by pressing [SHIFT] on
the sub remote control unit.
b
4
Press [MEMO] again to complete the setting.
To preset other stations, repeat steps 1 to 4.
Stations can be preset automatically at “Auto Preset” (vpage
63).
•
•
NOTE
Preset stations are erased by overwriting them.
Listening to Preset Stations
You can also operate via the main unit. In this case, perform the
following operations.
Press <TUNING PRESET>, then turn <SOURCE SELECT> to select the
preset radio station.
1
Press [A ~ G] to select the memory block (A to G).
2
Press [CHANNEL]
or
[1 ~ 8] to select the desired preset
station.
Button located on both the main unit
and the remote control unit
BUTTON
Button only on the main unit
<BUTTON>
Button only on the remote control unit
[BUTTON]
Symbols used to indicate buttons in this manual
<SOURCE SELECT>
<STATUS>
<TUNING PRESET>
ENTER
uiop
ENTER
[SEARCH]
[A ~ G]
[TUNER]
[MEMO]
[ TUNER]
[CHANNEL]
[BAND]
uiop
[0 ~ 9]
[TU f]
[MODE]
[TUd]
[SOURCE
SELECT]
Sub remote control unit
(MAIN mode)
(MAIN mode)
[SAT TU]
[SOURCE
SELECT]
[ SAT TU]
[TUd]
[TU f]
(MAIN mode)
(MAIN mode)
