103
Appendix
TipsSettingsConnections
Contents
Front panel Display Rear panel IndexRemote
Playback
Direct playback
Sound recorded in source is played as is.
1
Press PURE to select “DIRECT”.
Direct playback begins.
%
•While DSD signals are played back, “DSD DIRECT” is displayed.
Pure Direct playback
This mode is for playback with higher sound quality than in “DIRECT”
mode, by turning o the front panel display panel, which can eliminate
faint low level noise from creeping into sensitive analog circuitry.
1
Press PURE to select “PURE DIRECT”.
The display goes dark, and Pure Direct playback begins.
%
•In DIRECT and PURE DIRECT sound modes, the following items cannot be
adjusted.
•Tone (vpage137)
•Restorer (vpage137)
•MultEQ® XT (vpage139)
•Dynamic EQ (vpage139)
•Dynamic Volume (vpage140)
NOTE
•Video signals are only output when HDMI signals are played in the PURE DIRECT
mode.
•When the PURE DIRECT mode has been selected, the display turns o after about
5 seconds. The power indicator will remain lit (green). To restore the display press
PURE again, which will set the unit in DIRECT mode.
