111347-01B
For more information, visit www.desatech.com
For more information, visit www.desatech.com
19
19
CLEANING AND MAINTENANCE
Cleaning Burner Injector Holder and Pilot Air Inlet Hole (Cont.)
Logs
SPECIFICATIONS
Burner Tube
Pilot Assembly
Pilot Air
Inlet Hole
Ports/Slots
Burner Tube
Injector Holder (May
Be Brass or Aluminum
Depending on Model)
Primary Air Inlet Holes
(Shape of Holes May
Vary by Model)
Figure 29 - Injector Holder On Outlet Burner Tube
Figure 30 - Pilot Inlet Air Hole
CLEANING AND
MAINTENANCE
Continued
Clean the pilot assembly also. A yellow tip on the pilot flame
indicates dust and dirt in the pilot assembly. There is a small pilot
air inlet hole about two inches from where the pilot flame comes out
of the pilot assembly (see Figure 30). With the unit off, lightly blow
air through the air inlet hole. You may blow through a drinking straw
if compressed air is not available.
LOGS
• If you remove logs for cleaning, refer to Installing Logs, pages
13 and 14, to properly replace logs.
• Replace log(s) if broken or chipped (dime-sized or larger).
SPECIFICATIONS
Echo Valley Oak Log
Variable Manually-Controlled
Btu (Variable) 16,000/31,500
Type Gas Propane/LP - Natural
Ignition Piezo
Manifold Pressure 8.0" W.C. - 3.5" W.C.
Inlet Gas Pressure (in. of water)
Maximum 14" - 10.5"
Minimum* 11" - 5"
Shipping Weight 38 lbs.
* For purpose of input adjustment
Meadowbrook Oak Log
Thermostatically-Controlled
Btu (Variable) 26,000/39,000
Type Gas Propane/LP - Natural
Ignition Piezo
Manifold Pressure 8.0" W.C. - 3.5" W.C.
Inlet Gas Pressure (in. of water)
Maximum 14" - 10.5"
Minimum* 11" - 5"
Shipping Weight 28 lbs.
* For purpose of input adjustment
