134
create access_profile
the
config access_profile
command, below.
Parameters
ethernet − Specifies that the switch will examine the layer 2 part of
each packet header.
•
vlan − Specifies that the switch will examine the VLAN part of
each packet header.
•
source_mac <macmask> − Specifies a MAC address mask for
the source MAC address. This mask is entered in the
following hexadecimal format:
•
destination_mac <macmask> − Specifies a MAC address
mask for the destination MAC address.
•
802.1p − Specifies that the switch will examine the 802.1p
priority value in the frame’s header.
•
ethernet_type − Specifies that the switch will examine the
Ethernet type value in each frame’s header.
ip − Specifies that the switch will examine the IP address in each
frame’s header.
•
vlan − Specifies a VLAN mask.
•
source_ip_mask <netmask> − Specifies an IP address mask
for the source IP address.
•
destination_ip_mask <netmask> − Specifies an IP address
mask for the destination IP address.
•
dscp − Specifies that the switch will examine the DiffServ Code
Point (DSCP) field in each frame’s header.
•
icmp − Specifies that the switch will examine the Internet
Control Message Protocol (ICMP) field in each frame’s header.
•
type − Specifies that the switch will examine each frame’s
ICMP Type field.
•
code − Specifies that the switch will examine each
frame’s ICMP Code field.
•
igmp − Specifies that the switch will examine each frame’s
Internet Group Management Protocol (IGMP) field.
•
type − Specifies that the switch will examine each frame’s
IGMP Type field.
•
tcp
−
Specifies that the switch will examine each frames
Transport Control Protocol (TCP) field.
•
src_port_mask <hex 0x0-0xffff> − Specifies a TCP port
mask for the source port.
•
dst_port_mask <hex 0x0-0xffff> − Specifies a TCP port
mask for the destination port.
