7" Portable DVD Player
23
No forward or reverse scan
• Some discs have sections that prohibit rapid scanning or title and chapter skip.
• You cannot advance through the opening credits and warning information at the
beginning of movies because the disc is programmed to prohibit that action.
Bad sound quality
• Make sure that the audio output mode is set correctly.
• Make sure that the audio connection between the player and amplifier is correct.
Disc cannot be played
• Make sure that a disc is in the player.
• Make sure that the disc is placed on the disc tray correctly, with the label side up.
• Make sure you are using the correct type of disc (digital video discs, audio CDs, or
MP3s).
• Both the player and disc are coded by region. If the region codes do not match, the disc
cannot be played. This player is coded for Region 1 discs.
Remote control does not work
• Remove obstructions between the remote control and the player.
• Point the remote control at the remote control sensor of the player.
• Replace the battery with new ones.
To replace the battery:
1 While pushing in on the tab as shown in the following graphic, pull the battery tray
out of the remote control.
2 Remove the old battery, then insert a new battery with the + sign on the battery
facing up.
3 Push the battery tray back into the remote control.
Disc play starts, then stops immediately
• Both the player and disc are coded by region. If the region codes do not match, the disc
cannot be played. This player is coded for Region 1 discs.
• The disc is dirty. Clean it.
• Condensation has formed in the player. Let the player dry out, then try again.
Picture is distorted
• Inspect the disc because it might be damaged. Try another disc.
• It is normal for some distortion to appear during forward or reverse scan.
No power
• If running on AC power:
CR2025
Open
Push
