Using the PostScript Printer Driver 151
EPSON AcuLaser C3800 User's Guide
For Macintosh
Any Macintosh computer to which the printer is connected must be running Mac OS 9 ver.
9.1 or later, or Mac OS X ver. 10.2.8 or later. See the following table for details.
Note:
To use the PostScript 3 printer driver with a USB interface, your computer must be Macintosh OSX
10.3.9 or later.
Mac OS X
Note:
To use binary data, Epson recommends that you use AppleTalk for the printer’s network
connection. If you use a protocol other than AppleTalk for the network connection, you need to set
Binary to On in the PS3 Menu on the control panel. If you use the printer with a local connection, you
cannot use binary data.
Mac OS 9
Note:
To use binary data, Epson recommends that you use AppleTalk for the printer’s network
connection. If you use a local connection or a protocol other than AppleTalk for the network
connection, you cannot use binary data.
c
Caution:
❏ The Adobe PostScript 3 printer driver cannot be used on computers running System 9.0.x
or below.
❏ The Adobe PostScript 3 printer driver cannot be used on Macintosh 68K computers.
Memory 8 MB 16 MB
Minimum Recommended
Computer Power Mac G3, G4, G5, iMac, eMac, PowerBook G3, G4, or iBook
Hard Disk —
Memory 128 MB
Minimum Recommended
Computer Power PC
Hard Disk 3.1 MB free (for driver installation) 4 MB free (for driver installation)
Memory 4 MB 32 MB
