- 39 -
5.2.14 Caster pivot bearings pre-load adjustment
.
a) Remove dust cap from caster and tighten
nyloc nut until washers are flat and back
off 1/4 of a turn to properly set the pre-load
on the bearings. If disassembled, make
sure the spring washers are reinstalled as
shown in Figure 18.
5.2.15 Seat armrest adjustment
.
a) Lift armrest on seat. Locate square
tab marked with the numbers 1
through 4. Rotate square tab 1/4
turn to raise or lower the armrest in
approximately 1/4” (6.4 mm)
increments. See Figure 19.
6. WASTE DISPOSAL
6.1 MOTOR OIL DISPOSAL
Engine oil and hydraulic oil are both pollutants to the environment. Dispose of used oil at
a certified recycling center or according to your state and local regulations.
6.2 BATTERY DISPOSAL
DANGER
POTENTIAL HAZARD
♦ Battery electrolyte contains sulfuric acid, which is
poisonous and can cause severe burns
WHAT CAN HAPPEN
♦ Swallowing electrolyte can be fatal or if it touches skin
can cause severe burns.
HOW TO AVOID THE HAZARD
♦ Wear safety glasses to shield eyes, and rubber gloves
to protect skin and clothing when handling electrolyte.
♦ Do not swallow electrolyte.
Federal law states that batteries should not be placed in the garbage. Management and
disposal practices must be within relevant federal, state, or local laws.
If a battery is being replaced or if the unit containing the battery is no longer operating and
is being scrapped, take the battery to a local certified recycling center. If no local
recycling is available return the battery to any certified battery reseller.
7. TROUBLE SHOOTING
7.1 MOWER PULLS LEFT OR RIGHT (W/LEVERS FULLY FORWARD).
a) Refer to Tracking Adjustment Section 4.1.3.
b) Check air pressure in tires; 13 psi/drive, 13 psi/pneumatic casters.
FIGURE 18
CASTER ADJUSTMENT
Armrest Adjustment
Tab Rotate ¼ Turn
FIGURE 19
RMREST ADJUSTMENT
