QS-3USP 405 • Quick Start
2
Output menu
3
Memory Presets menu
4
Advanced Configuration menu
Output
Configuration
NEXT
Resol 1024 x 768
Refresh @ 60
Output Signal
RGB
Sync Polarity
H Neg V Neg
NEXT
NEXT NEXT
Input
Configuration
MENU
Scaler output rates
• See the table in the "Output Configuration"
section of chapter two for available
combinations of resolutions and refresh
rates.
Default: 640x480, 60 Hz
NOTE Lock = Accu-RATE Frame Lock™
Video types
• RGB (default)
• Y, R-Y, B-Y
Polarity combinations
• H-/V- (default)
• H-/V+
• H+/V-
• H+/V+
2
Output
Configuration
Advanced
Configuration
MENU
Edge Smoothing
OFF <ON>
NEXT
Encoder Filter
06
NEXT
Blue Mode
<OFF> ON
Top Blanking Bot
021 030
NEXT
RGB Delay
0.2 Seconds
NEXT
NEXT
Either Adjust knob is used
to adjust the submenus*
To reset the scaler, press
and hold the Freeze button
until reset message displays
Smooth edges
• On (default)
• Off
Encoder filter setting
• 0 thru 12 (default is 6)
to adjust sharpness
RGB delay time
(in seconds)
• 0.0 to 5.0 seconds
in 0.1 sec. increments
(0.7 second default)
Display blue and sync only
• On
• Off (default)
NEXT
Press and Hold
FREEZE to Reset
NEXT
Test Pattern
Off
NEXT
Set test pattern type
• Off (default) • Alt pixel
• Color Bars • Film aspect 1.78
• Crosshatch • Film aspect 1.85
• 4 x 4 crosshatch • Film aspect 2.35
• Grayscale • Ramp
• Crop
Top and Bottom Blanking
*
• Top blanking ranges from
000 (default) to 237
• Bottom blanking ranges
000 (default) to 237
Enhanced Mode
<OFF> ON
Enhanced mode (gain control)*
• On (default)
• Off
NEXT
PAL Film Mode
• On
• Off (default)
Input 2 PAL Film
<OFF> ON
NEXT
NOTE
Adjust knobs do not affect
this submenu.
*If the Test Pattern is set "On",
"Not Available" is displayed.
NEXT
Save Preset
<N/A> 1 2 3
Erase Preset
<N/A> 1 2 3
NEXT
NEXT
Saving (Save) memory presets
• Save the currently selected input's
sizing and centering information.
• Up to 3 presets per input can be
selected < > (N/A is the default) and
saved.
• Save a preset by pressing the Next
button.
Erasing (Erase) memory presets
• Erase the currently selected input's
saved sizing and centering
information.
• Up to 3 presets per input can be
selected < > (N/A is the default)
and erased.
• Erase a preset by pressing the Ne
xt
button.
Output
Configuration
Memory
Presets
MENU
3
