• Locate the battery compartment on the lights and
siren unit.
• Loosen the screw in the battery compartment door with
a Phillips screwdriver. The screw will remain in the door.
• Lift the battery compartment door to open it.
• Insert four “AA” (LR6) alkaline batteries as indicated on
the battery compartment door.
• Replace the battery compartment door and tighten the
screw with a Phillips screwdriver. Do not over-tighten.
Battery Tips
• Do not mix old and new batteries.
• Do not mix different types of batteries: alkaline, standard
(carbon-zinc) or rechargeable (nickel-cadmium).
• Remove the batteries during long periods of non-use.
Always remove exhausted batteries from the product.
Battery leakage and corrosion can cause damage.
Dispose of batteries safely.
• Never short circuit the battery terminals.
• Non-rechargeable batteries are not to be recharged.
• Only batteries of the same or equivalent type as
recommended in the “Battery Installation” instructions are
to be used.
• If removable rechargeable batteries are used, they are
only to be charged under adult supervision.
• Rechargeable batteries are to be removed from the
product before they are charged.
• If you use a battery charger, it should be examined
regularly for damage to the cord, plug, enclosure and
other parts. Do not use a damaged battery charger until
it has been properly repaired.
1.5V x 4
“AA” (LR6)
Shown Actual Size
Battery
Compartment
Door
Lights and Siren Unit
22
Lights and Siren Unit
Speaker
Front of Hood
Lights
and Siren
Unit Cord
23
• Insert the lights and siren unit cord through the hole in the
center of the hood.
• Fit the lights and siren unit to the top of the hood. Make
sure the speaker faces the front of the hood.
• Insert two #6 x
7
/
16
" screws with washers through the
holes in the underside of the hood and into the lights and
siren unit. (The #6 x
7
/
16
" screws and #6 washers can be
found in the small parts bag enclosed with the lights and
siren unit and microphone.)
Assembly
17
