T4274
www.fisher-price.com.au
Please keep this instruction sheet for future reference,
as it contains important information.
Requires three “AA” batteries (included) for operation.
Adult assembly is required.
Tool required for assembly: Phillips screwdriver (not included).
Battery Replacement Battery Safety
Information
For best performance, we recommend
replacing the batteries that came with
this toy with three, new “AA” (LR6)
alkaline batteries.
Locate the battery compartment on the •
back of the fridge.
Loosen the screws in the battery •
compartment door and remove the door.
Remove the exhausted batteries and •
throw them away.
Insert three, new “AA” (LR6) •
alkaline batteries.
Hint: We recommend alkaline batteries for
longer battery life.
Replace the battery compartment door •
and tighten the screws.
If this product begins to operate •
erratically, you may need to reset the
electronics. Slide the power switch off
then back on.
When sounds and lights from this toy •
become faint or stop, it’s time for an
adult to change the batteries.
In exceptional circumstances, batteries may
leak fluids that can cause a chemical burn
injury or ruin your product. To avoid
battery leakage:
Do not mix old and new batteries or •
batteries of different types: alkaline,
standard (carbon-zinc) or rechargeable
(nickel-cadmium).
Insert batteries as indicated inside the •
battery compartment.
Remove batteries during long periods •
of non-use. Always remove exhausted
batteries from the product. Dispose of
batteries safely. Do not dispose of this
product in a fire. The batteries inside may
explode or leak.
Never short-circuit the battery terminals.•
Use only batteries of the same or •
equivalent type, as recommended.
Do not charge non-rechargeable batteries.•
Remove rechargeable batteries from the •
product before charging.
If removable, rechargeable batteries are •
used, they are only to be charged under
adult supervision
Protect the environment by not •
disposing of this product with
household waste (2002/96/EC).
Check your local authority for
recycling advice and facilities
(Europe only).
1,5V x 3
“AA” (LR6)
Assembly
At an angle, fit the tabs on the top of the •
rubbish bin into the opening on the side
of the kitchen.
Then, push the bottom of the rubbish bin •
onto the posts on the kitchen.
Rubbish Bin
Turn the kitchen over and insert two •
#6 x 1,3 cm screws into the holes.
Tighten the screws with a Phillips
screwdriver. Do not over-tighten.
2 Screws
SHOWN ACTUAL SIZE
CAUTION
This package contains small parts in its unassembled state.
Adult assembly is required.
