MR-8HD/CD Supplementary manual
Before using the internal CD-R/RW drive of the MR-8HD/CD (or an external CD-R/RW
drive), read the following.
Usable discs
Only discs with any of the following logos can be used with the internal CD-R/RW drive of the
MR-8HD/CD (or an external CD-R/RW drive connected to the MR-8HD/CD [USB HOST] port).
Recordable
ReWritable
<CD-R disc>
You can make additional recording to a CD-R disc until it is finalized if it is brand
new and still has enough recordable area (additional recording is possible only in
the "Track at once" mode).
<CD-RW disc>
You can make additional recording to a CD-RW disc until it is finalized if it is brand
new and still has enough recordable area (additional recording is possible only in
the "Track at once" mode).
<CD disc>
You can view TOC information of a disc with this logo (such as a commercially
available CD) but you cannot make recording.
<Note>: Using the internal CD-R/RW drive of the MR-8HD/CD (or an external CD-R/RW drive
connected to the MR-8HD/CD [USB HOST] port), you cannot play back CD-DA discs you created
(or commercially available audio CDs).
Handling of CD-R/RW discs
• Handle a disc with care by holding them by the rim or
by a finger through the center hole, rather than
touching the surface. Do not get fingerprints, dust,
scratch, etc. on the signal side.
• Do not affix any labels or stickers to the label side of
the disc. Do not make a scratch on the label side.
A scratch may make recording or playback
impossible. Do not write on the label side of a disc
with a hard pen such as a ballpoint pen and a pencil.
Only use a soft pen.
• Do not use a curved or cracked disc, which may cause
malfunction of the drive.
• If dust or fingerprint is attached to the signal side, wipe
the disc gently with a soft dry cloth or a cloth with
ethyl alcohol from the center towards the outside edge.
Do not wipe it from the outside towards the center.
Please read before using
3
