23
920-087-02 (9-03)
Friedrich PTAC Accessories (continued)
PXSE
SLEEVE EXTENSION RETROFIT KIT G-90 zinc coated
steel, 2.4" sleeve extension attached to the room side of
the sleeve to allow for the installation of a P-Series Friedrich
PTAC in a T-Series sleeve.
PXDA
LATERAL DUCT EXTENSION A three foot insulated plenum
that attaches to the left or right side of the duct adapter. The
extension can be cut to length by the installer. Maximum
allowable straight extension is fteen feet.
PXDE
PXFT
SEACOAST PROTECTION Additional protection for PTAC/PTHP units in a coastal or corrosive environment.
The entire outdoor coil is submerged in a specially formulated enamel coating, then oven-cured for a tough,
corrosion-resistant nish.
C
STANDARD UNIT Standard PTAC/PTHP chassis. Can be 230/208V or 265V, electric or heat pump.
REMOTE THERMOSTAT Chassis option necessary for wall mounted thermostat control of the unit.
REPLACEMENT FILTER PACK These are original
equipment return air lters. They are reusable and can be
cleaned by vacuuming, washing, or blowing out, and are sold
in convenient ten packs. (Two lters per chassis)
LATERAL DUCT ADAPTER Attaches to the PTAC/PTHP
unit and provides a transition to direct up to 35% of the total
CFM to a secondary room, either left or right of the unit. Kit
includes duct plenum with discharge grille and internal bafe,
adapter and end cap.
S
R
ADDITIONAL ACCESSORIES
MODEL NUMBER DESCRIPTION PHOTO
DESCRIPTION DESIGNATOR
CHASSIS OPTIONS
PXSE
PXDA
PXFT
